need help
sir i need 15 inch top speaker seal cabinet design for single and dual speaker and 24 db bass crossover for 18 inch bass reflex enclouser.thanks
sir i need 15 inch top speaker seal cabinet design for single and dual speaker and 24 db bass crossover for 18 inch bass reflex enclouser.thanks
Hello ....
Hello,
Please, tell us how to setup the limit to 20 W tweeter for this schematic ...
http://www.diyaudio.com/forums/atta...-x-over-mosfet-protect-not-compress-peaks.jpg
http://www.diyaudio.com/forums/pa-systems/174053-diy-pa-speakers-setup-line-array-8.html
what to change as resistor ... caps ... ??
Also ... how to setup this one for 20 W ... ?
http://www.diyaudio.com/forums/atta...-hf-x-over-bjt-protect-not-compress-peaks.jpg
Thank you in advance,
Emil
Hello,
Please, tell us how to setup the limit to 20 W tweeter for this schematic ...
http://www.diyaudio.com/forums/atta...-x-over-mosfet-protect-not-compress-peaks.jpg
http://www.diyaudio.com/forums/pa-systems/174053-diy-pa-speakers-setup-line-array-8.html
what to change as resistor ... caps ... ??
Also ... how to setup this one for 20 W ... ?
http://www.diyaudio.com/forums/atta...-hf-x-over-bjt-protect-not-compress-peaks.jpg
Thank you in advance,
Emil
DIY PA speakers line Array
I have been reading your articles from here and other forums, how is the Quasi double 18 sound and can I use Faital Pro 18" Neodymium? And do you have any plots from other woofers? Thanks🙂
I have been reading your articles from here and other forums, how is the Quasi double 18 sound and can I use Faital Pro 18" Neodymium? And do you have any plots from other woofers? Thanks🙂
Plots from simulator do not have anything common with real life measurements... You can use Faital Pro 18 in Quasi Horn and you can espect 4-6dB greater SPL from 80 to 150Hz compare to bass reflex.
Regards
apex audio can you recommend a nice Faital neo 18" for this Double 18" Quasi horn? With mid Qts. like Qts .31? Thanks!
Eh I don't mean to be rude but.. What kind of program did you use for THAT?
The panels aren't connected or square drawn, and the measurements aren't put in place properly.
If you can get me some more measurements I can make a flat drawing and 3D view in my V20 version of Solid Edge.
