More than 5Kw output and less than 0.09% distortion from 20 hz to 20 khz, good for low freq. and lower mid as distortion less than 0.037%at up to 1khz, Load showing more than 10 kw at 0.5 ohm, more than 5 kw at 1ohm load, with 28 pair in output will deliver more than 5 KW.continuous . Designed by Vedmitra.



I have a few questions- When will the PCB's be made available? What is the idle consumption? What are the -3dB points? What is the harmonic and intermodulation spectrum like at different frequencies and various power levels? How stable is it into reactive loads? What kind of reactive load does this design place on the preamp upstream? Thanks ya'll.
This ciruit looks woking well by simulation and physical values requires application. pcb of the driver shall be fine and could be your contribution , also enough for realizing if you mean that the pcb cannot handlle the current. Safety operation requires adding power factor correctors and also.
Last edited:
This topic is just been shared and does not give any warranty for all probabilities, but basically it is a working circuit . information about necessary modifications requires expertise and cannot being answered by me.
A 10kW amp is more for places like sports stadiums.
Was it about 25 years ago the Crown MA-10,000 came out?
http://www.crownaudio.com/media/pdf/legacy/k10684.pdf
Was it about 25 years ago the Crown MA-10,000 came out?
http://www.crownaudio.com/media/pdf/legacy/k10684.pdf
http://obrazki.elektroda.pl/6788430000_1292666421.jpg
the crown ma10000 is also produced as techron8607 isn't?
the crown ma10000 is also produced as techron8607 isn't?

simple scematic for that huge power amp. is it work on real world?
Practically not, or it will be huge sized.
Sajti
An externally hosted image should be here but it was not working when we last tested it.
Oké, this is nice. But do You see 5.8kW dissipation? And what kind of power supply will You use for this amp?
Sajti
İs Haarlem ver vanaf Dieren,; daar ben ik geboren..
Haarlem is on the other side of the country from Dieren, but it's a small country... I've been in Dieren a few times when I worked on a filter for pacemakers for Vitatron (which company doesn't exist anymore, according to Wikipedia).
To get back on topic: I know from experience that it is very easy to get permanent tinnitus, so please be very careful with this amplifier!
- Home
- Amplifiers
- Solid State
- class AB 10.000W RMS @0.5R - 20.000W rms bridged