Well, still having bad luck with he APOX stuff. Ik think the volume board developed a problem (again). It creates a loud humm even when the amp is off. It also turns on my Hypex power-amps one way or another whhile it is only connected through an interlink.
At this point I'm seriously considering to do something bad to the guy who sold me the APOX stuff and said it was working as it should.
At this point I'm seriously considering to do something bad to the guy who sold me the APOX stuff and said it was working as it should.
Today the Dantimax boards arrived. Looks great. So let's see if I can finish this project without having the need for serious medication
witch resistor set for the volume control did you order?
or is it potmeter your using?
dont use it. you need a 10K resistor set and place the control on the output.
i tryed 1K in the input. but the level was very low up to -7db
ehm. this was wrong. 10k on the input. i tryed 1k on the output.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- APOX volume-input for Aleph P1.7 question