Had a very busy day, here it is. FB is ferrite bead, FTC is feedthrough cap, led r is calculated based on voltage (and current trough led depending on how bright you want it( so no value. Bit ugly but tired to do CRIF and bom designators 😴
Per a BOM from the main thread I sit with this TVS diod. It says uni-directional - so one need to care of its direction?
https://www.digikey.se/en/products/...ESflQjT5Di1rPfk6sx7A28pzAM5JTZxOlLD094PyzhykR
//
https://www.digikey.se/en/products/...ESflQjT5Di1rPfk6sx7A28pzAM5JTZxOlLD094PyzhykR
//
Just like that yes 🙂
For the last couple of months it has been 4-5h on average 😅sleep 🙂
Wanted to share a couple that I built. First one was to filter from a SMPS to a balanced buffer for an amp I’m building. Then I built a double filter box for a phono preamp and an audio interface for a record ripping setup. Ordered like 20 PCB’s so planning on putting them on everything!
Thank you for the design!
Thank you for the design!
Attachments
-
IMG_8371.jpeg387.2 KB · Views: 40
-
IMG_8372.jpeg689.8 KB · Views: 41
-
IMG_8376.jpeg809.5 KB · Views: 45
-
IMG_8378.jpeg328.4 KB · Views: 44
-
IMG_8402.jpeg326.6 KB · Views: 40
-
IMG_8369.jpeg721.6 KB · Views: 39
-
IMG_8363.jpeg559.4 KB · Views: 44
-
IMG_8362.jpeg940.7 KB · Views: 46
-
IMG_8413.jpeg682 KB · Views: 45
-
IMG_8091.jpeg849.1 KB · Views: 43
-
IMG_6738.jpeg668.6 KB · Views: 41
-
IMG_8404.jpeg467.5 KB · Views: 42
- Home
- Amplifiers
- Power Supplies
- AmyAlice SLIM - SMPS filter