Send me your shipping address and I'll send you the Harris triplet.
Package from Mr. Harris arrived!
After cooking for a couple of hours i now have 212-228mV on all 12 critters. Sub mV offset.
Thank you Pa!
Attachments
Got my BA-3 and Whammy up and running and they sound great! Still chip rolling, but the two are great with my DT-1990 and Clear MG.
As I finished stuffing my F4, the 4U chassis arrived! I gotta say, it's a much tighter fit than I was expecting. I'm thinking about splitting the PSU board so the transformer can be centered. Wiring will be...fun...XD
As I finished stuffing my F4, the 4U chassis arrived! I gotta say, it's a much tighter fit than I was expecting. I'm thinking about splitting the PSU board so the transformer can be centered. Wiring will be...fun...XD
Attachments
Did you try to place the toroid in a upright position? With te cap-bank turned 90° you‘d get a symmetrical arrangement, And you would have all in 1 chassis. Not sure about switch, led, and rectifiers though…
Here’s mine, 4u 300 mini… (toroid laying around under the capbank )
Here’s mine, 4u 300 mini… (toroid laying around under the capbank )
Attachments
Wiring coming along! Calling it a night due to lack of usable light and beer. Transformer and power lines to be installed tomorrow or Monday. Yeah, keeping the xfmr on the right side; easier to work and it's an amp, not a jet. I don't care where its CG is!
...and cheap channel delay for echo effect.why I didn't ever think of that - having PSU wires longer to one channel and xformer closer to same one ....... just leads to greater entertainment factor!
you have myriad of pics, taken from Kosher builds
if you keep it symmetrical, no troubles
xformer all the way up to front plate , then bridges then Cap Bank centrally
equal length of power wires to channels, easy arrangement of signal wires to avoid ground loops
as I'm always saying - if in doubt - look at original FW pics - plenty of those around
6moons site, for example - almost every FW amp covered with high res content
if you keep it symmetrical, no troubles
xformer all the way up to front plate , then bridges then Cap Bank centrally
equal length of power wires to channels, easy arrangement of signal wires to avoid ground loops
as I'm always saying - if in doubt - look at original FW pics - plenty of those around
6moons site, for example - almost every FW amp covered with high res content
To Luddites it is you...but, with time, I'm trying to learn who is .......
- Home
- Amplifiers
- Pass Labs
- A guide to building the Pass F4 amplifier