thanks for reply mrching.
but 2 10000uf caps in series reduced to 5000uf, is it correct?
thanks for reply sir.
so in this situation is this power supply enough to run two channels of h900.?
Dear Apex, thanks for reply
yes i have two channels but i test one by one with one 750va transformer , voltage at DC side 110-56-0-56-110 , clipping found when voltage try to step to high rail(voltage measure at both fuses +/- 58v to 65 when clipping)
I use uf4007 instead of BAV21 & MUR1560 in circuit.
sorry for poor english
I can't suggest to use H900 with 2R load, but many brand class H amps with 4 pairs of outputs suggest 2R load (crown, QSC...).
I suggest H900 with 7 pairs of outputs for 2R load.
HI APEX SIR,
i edited with 7 pair. only right side finished.
pls check for errors.
i put two 4.7k/5w resistors in parralel to reduce the heat.
is it ok to drive 7 pairs with this drivers.
there is error transistor place c5200 instead a1943.
i edited with 7 pair. only right side finished.
pls check for errors.
i put two 4.7k/5w resistors in parralel to reduce the heat.
is it ok to drive 7 pairs with this drivers.
there is error transistor place c5200 instead a1943.
Attachments
Last edited:
For 7 pairs of outputs you must use predrivers in triple emiter folover topology.
hi apex sir,
one of my customer asked for 300w and 500w into 4ohm load amp,so if i reduced the power voltages. i think its ok. so for 300 and 500w what is the dc voltage to provide for this h900?
one of my customer asked for 300w and 500w into 4ohm load amp,so if i reduced the power voltages. i think its ok. so for 300 and 500w what is the dc voltage to provide for this h900?
Last edited:
