HI soerdjanto your 2sa1943 collecter is attached with +ve side on mur1620 its wrong you will attached -ve side pls check schematic
power amp
anyone have a pcb component side for an xlr input?ive seen it in the thread but i cant remember where.
anyone have a pcb component side for an xlr input?ive seen it in the thread but i cant remember where.
Is this correct Sir??
Regards
R24 and R25 must be connect to +/-MV, add BAV21 in paralel with 100pF on drivers and it can work.
Regards
another H900 revolution,
this v. is good easy to find parts
how about the switching
will this be a better one?
this v. is good easy to find parts
how about the switching
will this be a better one?
Like this???R24 and R25 must be connect to +/-MV, add BAV21 in paralel with 100pF on drivers and it can work.
Regards
With only one mosfet on step driver,how much final transistor can be use???
Regards
Attachments
Like this???
With only one mosfet on step driver,how much final transistor can be use???
Regards
This is OK, 4 pairs is maximum with this topology, for more outputs you must add predrivers (triple darlington) and more step mosfets.
Regards
Ok..thank you Sir....This is OK, 4 pairs is maximum with this topology, for more outputs you must add predrivers (triple darlington) and more step mosfets.
Regards
Regards
sir mile,
if two mosfet should be use in 4 pair of output,how many mosfet in 6 pair,8 pair,how to determine step drive mosfets?
if two mosfet should be use in 4 pair of output,how many mosfet in 6 pair,8 pair,how to determine step drive mosfets?
sir mile,
if two mosfet should be use in 4 pair of output,how many mosfet in 6 pair,8 pair,how to determine step drive mosfets?
Use 2, 3 or 4 IRF540 mosfets, IRF2807 can be use for 4 outputs.
hi soerdjanto
what is the news about h900 with speaker protector
i'm waiting ..................
what is the news about h900 with speaker protector
i'm waiting ..................
h900 with speaker protector
already on trial, and the results are okay
An externally hosted image should be here but it was not working when we last tested it.
Sir Plz send pcb layout pdf file
@ ravpreet420 pls be aware that this design have some error example look pin 5 of the ic ne5532
try to compare with this
try to compare with this
Attachments
Last edited:
@irvynejay,sir did you build the 700 watts leach amp?im planning to build it too for my 2 18 inches sub.what do you think is good for sub?h900 by apex or the leach 700 watts?thanks sir.
@irvynejay..sir did you build the 700 watts leach amp?im planning to build it for my sub 2 pcs 18 inches.what do you think is good for 18 inches sub,h900 by apex or the leach amp?
yes i did build it leach 700w but in 2 r witch is not good ,so far H900 is more clear and punchy to me
Thanx irvynejayyes i did build it leach 700w but in 2 r witch is not good ,so far H900 is more clear and punchy to me
h900
boss apex, I have available power supply 97-48-0-48-97, can iI use that power supply for h900?
boss apex, I have available power supply 97-48-0-48-97, can iI use that power supply for h900?
- Home
- Amplifiers
- Solid State
- 900W H-class PA Amp with Limiter