Very nice Damir, how much voltage will it stand? Will it do 100 volts and 20 amps? Again great work...😀
Hi Chris,
It was designed for +-75 V input and the output is about 6 to 7 V lower.
No need for more then that is needed in my opinion, you can have a bit more then 200W/8 with it. If needed more better to go bridged. High voltage transistors are distinguished and high voltage high capacity electrolytic capacitors are expensive.
Yes I have enough AMP boards (both those with no soldering mask errors and those with small soldering mask errors) and some PS regulator boards.
Have not received them yet.I have a friend who is very keen on my symasym amp so your're amp will replace it.BR Manuel
Manuel, that is very strange. I can see from tracking no. RB945220142HR that first delivery was unsuccessful attempt date 10.02.2016.
Please check with your post office.
For the regulator just ordinary red and green LEDs, red means regulator protection on, green means power on.
For the amo also ordinary red just try to match the voltage at let say 2 mA.
I used this one.
Looks great! Especially in "Big Boy" enclosure 🙂 Are you using a single regulator board for both side? What's your listening impressions? Are there PCB's available?
Thank You
Thank You
Yes, I am using a single regulator boards, and it's to early to talk about listening impression, so far so good.
I still have some boards.