ax17 bisa set
rail...what is the best bias voltage?
and i too made that with 2 pair mj15024/mj15025 with +50/0/-50 volt rail...and what is the best bias for this in ab class?
hi mr mile.i made ax17 with 2pair mj2955/2n3055 and +35/0/-35
rail...what is the best bias voltage?
and i too made that with 2 pair mj15024/mj15025 with +50/0/-50 volt rail...and what is the best bias for this in ab class?
Hi Folks,
I have asked JPS64 to work up a new layout for the popular FH9 using all the latest tricks of the trade from a professional designer. We will make it based on the FH9HV and have certain component upgrades and things to make installation easier. It will be called the FH9HVX. Stay tuned...
Cheers,
X
I have asked JPS64 to work up a new layout for the popular FH9 using all the latest tricks of the trade from a professional designer. We will make it based on the FH9HV and have certain component upgrades and things to make installation easier. It will be called the FH9HVX. Stay tuned...
Cheers,
X
Here is a better layout for using TO3P outputs so they can be attached to heatsinks.
Attachments
Still4given, ur a master with this, thank you. What program are you using to get these? I havent tried to do any layouts, but i would like to learn. From taking a schematic and getting the end result like your pcb's
I'm using Sprint-Layout 6.0
I had some help from a few of the guys here on the forum to get me started. I am much better at editing layouts created by others than creating them myself from a schematic. Prasi amazes me at how quickly he can come up them. He uses Eagle. I tried that but just couldn't get my head wrapped around it.
I had a laptop fail on me and I lost most of my macros so I am gradually recreating them.
Im going to give Sprint Layout 6.0 a try, thank you. I actually have it, but stumbled right at the begining and just left it. It gave me headaches
Thanks X 🙂
I threw everything I had on hand to stuff these guys!
Hopefully tomorrow I can drill/tap and get the mounted on heat sinks.
I threw everything I had on hand to stuff these guys!
Hopefully tomorrow I can drill/tap and get the mounted on heat sinks.
i can not find PSU15pcb or schematic!!!!!!
any body have psu15 schematic.....!!!
any body have psu15 schematic.....!!!
Last edited:
best wish for you.
psu15 work at 40to 70 volt ac...my transformer is 25 volt ac....it have problem or no?
Last edited:
PSU15
Hi Mr. Mile,
Can I use PSU15 to drive a pair of A40 amplifiers? Transformer would be 45-0-45 volt AC 12Amps. Output regulated to 55-0-55 volt DC.
Could you please advise.
Thanks
Sha
Hi Mr. Mile,
Can I use PSU15 to drive a pair of A40 amplifiers? Transformer would be 45-0-45 volt AC 12Amps. Output regulated to 55-0-55 volt DC.
Could you please advise.
Thanks
Sha
Hi all,
What the correct arrangement for buffer and volume pot?
A or B?
or have better idea?
