sorry to insist, but maybe the message went missed.
at the very beggining of the gb i have asked the gerbers for the past layer of the main + control board. i have an active order on Jlc at the moment, and i still have time to include the stencil with that.
can you please link them somewhere ? thanks
Sorry your request went out of my mind as very busy.
Difficult to handle each of you particular request.
I did take some note on the excel file for the next step (shipping) and some max amount that some of you want to put on the parcel for tax declaration.
But on your side I completely forgot about this (and keep in mind that for some PCB I only have the gerbers as designed by others).
Anyway no problem to assemble the PCB without the paste and this preamp is relatively easy to assemble.
A good new, despite that the delivery was expected next monday I just received everything now in my office. Strange but nice !
So I have 5 heavy parcels full of PCB to open
I won't unfortunately be able to start making parcels for you guys this week end as I am leaving Saturday morning, but I will spend some time on this on the week end after.
I hope that by mid of July some of you get their PCB in their hands
So I have 5 heavy parcels full of PCB to open
I won't unfortunately be able to start making parcels for you guys this week end as I am leaving Saturday morning, but I will spend some time on this on the week end after.
I hope that by mid of July some of you get their PCB in their hands
i know it is easy. but as i am completly equipped to do a complete board reflow, for me (and maybe for others...) could be faster and cleaner.
anyway, just a reminder, you gave me an "ok" here about that.
The pcb's i have asked for i guess is made by you... so i don't think there is any licensing problem.
BTW... if you don't want to share them for any reason, just tell me straight. is in your rights
please, don't be jumpy... neither you need to threaten a refund. missing the point of view.
I made a question : "can I (we) have the paste layer in order to be more efficient and clean on the build ?"
Then the answer was "ok"... and then, another one went like "you can do by hand".
From my perspective, sounded like you have no interest or willing to share them, otherwise something like "sure, at the moment i have no time to produce them, but i will in the near future" would have been more indicative.
Just that, no drama...
I have pushed a little on that just because i had an open-order on Jlc and i was able to slip the gerber into that (without doing another order). so if they were available i would have taken them.
It's easy to mis-understand here...
My reply was not emotional neither I was jumpy.
One more time I forgot about your special request nothing more than that as I don't have only this GB in my mind (I wish I have).
And I was not threatening I was just proposing to refund if you feel I did wrong, no problem on my side to do it if needed.
Anyway explanations done I guess and we can move on.
Dear all I am back.
First a teaser of the PCBs
My plan is to start packing a bit every evening this week and start shipping.
I will get back to you one by one with the detail after sending the parcel.
If any of you as a special request for the shipping please remind me, I know some of you sent me some PM that I will check carefully before shipping.
First a teaser of the PCBs
My plan is to start packing a bit every evening this week and start shipping.
I will get back to you one by one with the detail after sending the parcel.
If any of you as a special request for the shipping please remind me, I know some of you sent me some PM that I will check carefully before shipping.