FS: Zilchlab Econowave Crossover PCBs
Before Zilch passed away he asked me to keep these crossover boards available and in consistent production for speaker builders everywhere. Pairs are available direct from me for $32 shipped CONUS w/instructions. Send me a PM if you'd like to build a pair of Zilch's Econowave speakers.
For more specific build information check out the massive original thread here on Audiokarma: Zilch's AK Design Collaborative - Econowave Speaker | Audiokarma Home Audio Stereo Discussion Forums
Not to mention Flex Your PCD Mettle on the Parts Express site where he really picked up steam: Flex Your PCD Mettle: - Techtalk Speaker Building, Audio, Video Discussion Forum
Before Zilch passed away he asked me to keep these crossover boards available and in consistent production for speaker builders everywhere. Pairs are available direct from me for $32 shipped CONUS w/instructions. Send me a PM if you'd like to build a pair of Zilch's Econowave speakers.
For more specific build information check out the massive original thread here on Audiokarma: Zilch's AK Design Collaborative - Econowave Speaker | Audiokarma Home Audio Stereo Discussion Forums
Not to mention Flex Your PCD Mettle on the Parts Express site where he really picked up steam: Flex Your PCD Mettle: - Techtalk Speaker Building, Audio, Video Discussion Forum
Attachments
New member and First-time poster here, a speaker mod newbie...
Wiredbecker, I've just sent you a PM -- I'm hoping to get boards (and everything else!) for converting a pair of original large Advents to whatever waveguide and driver is recommended (and affordable) -- I understand the Selenium model 220 8 ohm compression driver with a Pyle PH612 waveguide are recommended for the OLAs.
I appreciate any info. Thanks!
- Bob
Wiredbecker, I've just sent you a PM -- I'm hoping to get boards (and everything else!) for converting a pair of original large Advents to whatever waveguide and driver is recommended (and affordable) -- I understand the Selenium model 220 8 ohm compression driver with a Pyle PH612 waveguide are recommended for the OLAs.
I appreciate any info. Thanks!
- Bob
FS: Zilchlab Econowave Crossover PCBs
Before Zilch passed away he asked me to keep these crossover boards available and in consistent production for speaker builders everywhere. Pairs are available direct from me for $32 shipped CONUS w/instructions. Send me a PM if you'd like to build a pair of Zilch's Econowave speakers.
For more specific build information check out the massive original thread here on Audiokarma: Zilch's AK Design Collaborative - Econowave Speaker | Audiokarma Home Audio Stereo Discussion Forums
Not to mention Flex Your PCD Mettle on the Parts Express site where he really picked up steam: Flex Your PCD Mettle: - Techtalk Speaker Building, Audio, Video Discussion Forum
Sent you a pm
I'm confused about how this board is set up. The Jackgiff schematic for Econowaves shows the LP2 attenuator port going to + of the HF driver, but published schematics show the Zilch LP2 going to the - terminal. This board is showing the LP2 terminal going to the + terminal like the Jackgiff schematic, not the Zilch schematic. Was the Zilch schematic incorrect or does it not matter?