Rockford Fosgate BD10001

[Perry Babin]

The subsonic switch has 6 pins. I tested the midlle two. One pin has no signal either position. The outer middle pin towards the edge of the board has a good signal in one orientation and the same funny looking signal in the other position. The signal clips up top then the bottom wave form jumps on top and gives a square signal in between the wavey signal of the top wave form.

What if you reduce the signal so that the sine wave isn't clipped? Do you then have a symmetrical sine wave?

 

[seankane]

I will check this later and get back to you, just bringing it back up top.