I nearly lost one of my lungs after reading that.
hahaha
Why is everyone so mean to Zen Mod lately? hahahahaha
hahaha
Why is everyone so mean to Zen Mod lately? hahahahaha
Mean, I am not mean..... 🙂) I try to decipher his words.
Dodossess, #101 that are all secret audio codecs...
Dodossess, #101 that are all secret audio codecs...
Last edited:
I just had one major brain fart,
When I said 50mA zero tempco, I was out by 1 order of magnitude. Should have said 500mA.
Gee I'm a dumb bastard. Hahaha
Ok Laterals are a little better for temperature coefficient but Toshibas aren't that terrible if biased in the same range as the laterals.
When I said 50mA zero tempco, I was out by 1 order of magnitude. Should have said 500mA.
Gee I'm a dumb bastard. Hahaha
Ok Laterals are a little better for temperature coefficient but Toshibas aren't that terrible if biased in the same range as the laterals.
Hope is already with you..... 🙂
its a fun to play with the pucks, easy to mount, screws to attach the wires, so much surface.
its a fun to play with the pucks, easy to mount, screws to attach the wires, so much surface.
I just had one major brain fart,
When I said 50mA zero tempco, I was out by 1 order of magnitude. Should have said 500mA.
Gee I'm a dumb bastard. Hahaha
Ok Laterals are a little better for temperature coefficient but Toshibas aren't that bad if biased high enough.
but in the frontend we use normally 36-50mA...
but in the frontend we use normally 36-50mA...
Yes but the Laterals need 200mA to hit zero tempco.
Compared to what? Nothing wrong with your circuit though.Adding the local negative feedback resistor Rlfbn will get rid of excess open-loop gain and lower the output impedance of the FE stage.
My circuit doesn't have excess open loop gain.
o.k. lhquam, is there an advantage over the Cascode Feedback? Papa praised it ....
I already told you the benefit of cascode feedback.
I may as well be talkin to a brick wall. Hahahaha
Last edited:
Hope is already with you..... 🙂
its a fun to play with the pucks, easy to mount, screws to attach the wires, so much surface.
I already have plenty of pucks, just not the ones needed to build this amp.
Hope they arrive before Christmas.
Has anyone thought about just using a cap to bypass the source resistors ?
Ok the value would need to be rather large but on the other hand it would
at a low voltage .
Ok the value would need to be rather large but on the other hand it would
at a low voltage .
- Home
- Amplifiers
- Pass Labs
- F4 Beast Builders