Crossover help needed for Dynaudio 17W75XL(ohm) and D260

[Alfetta87]

PM sent

 

[gordonhunsaker]

Hi Daniel,

Looking forward to your reply later. For now I thought I'd attach the basis of my x-over design as it is from Dynaudio's Sirius kit design but modified for the 8 ohm version 17W75XL instead of the 4 ohm which this original Dyn DYI kit/version was based on. Had added extra coil for woofer low pass to accommodate 8 ohm impedance versus 4 ohm. Perhaps the other sections above standard zobels on both woof and tweet are not necessary but again I'm looking forward to your comments...

Thanks,
Gordon

 

[Alfetta87]

Hi Gordon,
Please send me your Email address.


Rgds,
Daniel

 

[gordonhunsaker]

Daniel,

It is: gordon_hunsaker@yahoo.ca

Thx,
G.

 

[gordonhunsaker]

Daniel,

Picture of speakers:

Gordon

 

[ShaneF]

I can tell you that the sirius crossover is very good. That is what I am running.

 

[gordonhunsaker]

Yes I recall your preference for it. Your comments actually lead me in that direction to try it and it will remain with my speaker config. albeit modified for the 8 ohm version woofer.

Cheers again,
Gordon

 

[preludes]

Hi Gordon & everyone,
I embark on the realization of crossover for these speakers also and I see that you have brilliantly succeeded!
Could I ask you for the list of components used?
Thank you !