Hi Daniel,
Looking forward to your reply later. For now I thought I'd attach the basis of my x-over design as it is from Dynaudio's Sirius kit design but modified for the 8 ohm version 17W75XL instead of the 4 ohm which this original Dyn DYI kit/version was based on. Had added extra coil for woofer low pass to accommodate 8 ohm impedance versus 4 ohm. Perhaps the other sections above standard zobels on both woof and tweet are not necessary but again I'm looking forward to your comments...
Thanks,
Gordon
Looking forward to your reply later. For now I thought I'd attach the basis of my x-over design as it is from Dynaudio's Sirius kit design but modified for the 8 ohm version 17W75XL instead of the 4 ohm which this original Dyn DYI kit/version was based on. Had added extra coil for woofer low pass to accommodate 8 ohm impedance versus 4 ohm. Perhaps the other sections above standard zobels on both woof and tweet are not necessary but again I'm looking forward to your comments...
Thanks,
Gordon
Attachments
Yes I recall your preference for it. Your comments actually lead me in that direction to try it and it will remain with my speaker config. albeit modified for the 8 ohm version woofer.
Cheers again,
Gordon
Cheers again,
Gordon
