MOoly, I used these in my Yam 640, Mouser part# 606-cm2182. They were perfect for my Yam Receeiver... Rubber boots slipped in perfect. A bit of a pain soldering those dinky wires.
Its not me that needs them Sounds like they might be just the ticket for our friend.
I'd had spent many hrs researching these... I recomend replacing 1 bulb at a time, so not to screw up wires and ALL the bulbs need to be replaced, because some of the bulbs are hooked in series and draw diffenent currents. If you screw up the wiring, it can burn out the pwr supply for the bulbs. It's time consuming and not much fun, till your done....
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Design & Build
- Parts
- yamaha cr600 replacement bulbs