where should i wire in a power indicator lamp on my Bell Air project amp

[doctor underhill]

trying to figure out where is the correct way to go about wiring in a power indicator lamp on my project Bell Air amp.

 

[rayma]

Gonna need a schematic.

Do you want to use a 120VAC lamp?

 

[HollowState]

I use different styles of pilot lights. Some LED and some incandescent. LEDs go across the transformer primary and small incandescents across a 6.3v filament line.

 

[rayma]

If that electrical-taped connection is just loose in the chassis, add an insulated terminal tie point for it.

 

[russc]

A knot in the cable is unsuitable as strain relief.
Cable must be clamped to prevent the cable twisting.

 

[67339]

WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
Building, troubleshooting and testing of these amplifiers should only be
performed by someone who is thoroughly familiar with
the safety precautions around high voltages.