Inside dims are 2.5 in wide x 2.0 in deep 23.25 in tall. Was thinking about a small tweeter in the center and 2 full range 3in woofers flanking the tweet.You could stand them up as small desk top towers or lay them flat as center channel.
Wouldn't hurt to try would it.
A cabinet brace might be a useful addition for the 23" dimension.
Do you have any thoughts on drivers, you will need to look for a pair of drivers that will work happily in that volume.
I haven't had any experiences of any drivers less than 5" midwoofers, so not easy to make suggestions for you.
Maybe Planet10 could make some suggestions mark audio, Sb acoustics or Peerless 3 full rangers.
A cabinet brace might be a useful addition for the 23" dimension.
Do you have any thoughts on drivers, you will need to look for a pair of drivers that will work happily in that volume.
I haven't had any experiences of any drivers less than 5" midwoofers, so not easy to make suggestions for you.
Maybe Planet10 could make some suggestions mark audio, Sb acoustics or Peerless 3 full rangers.
Last edited:
Good morning and thanks for the reply.The inside volume is 116.5 cu in or .067 cu ft. I found these drivers on P.E.'s website. Peerless TC2X4FB00-8....PE#264-1614.at only $15.00 ea. Recommended sealed is .045 (96hz) or vented .098 (51hz) so I am right in the middle. But box volume can be adjusted using a few tricks. I will be using these in conjunction with an 8in sub so looks like sealed is the way to go here. Alot less mind work there.Would you suggest a X-over for these keeping anything below 100hz from getting to these drivers?
I'd turn one in a sound bar for a tv set and the other one as sound reinforcement to a desktop computer. Left and right side reserved for a 2 way speaker, central part of cabinet to hold amplifier and power supply.
Lojeck....I have the sound part of my pc pretty much covered... but would be nice to cover the center a little better...Thanks for the suggestion...didnt think of that
That's was completely genuine! Trust me I was married twice and completely understand the WAF! Certain factor's need to be followed , size shape color and most importantly the cost! But I just don't have a WAF, I have a MAF ! That's a My acceptance factor! Just thought I'd just rub it in a little! Haha
Trash towers have been cleaned up ,sanded and resanded. looking alot better ordered all the parts needed . Decided to go with a small tweeter and a 3in. full range woofer but added a3in. passive radiator Went with a 2 way passive x-over at 4,000. Will post as the project progresses!
