BTW - when you shorten the inductor wire, scrape off the clear coating, clean with emery and resolder for the new connection.
um yeah i did get a 2.7, i thought that being so close that i would have to alter it less and would have better chance of being near 2.5
is this a problem, should i just unwind it 3 or 4 rounds?
oh and btw i got 3 5 watt resistors, a 2.7, a 3.3 and a 4.7(should have been 3.7 but they got it wrong and i didnt check)
Okay and as for the box i will design my own, possible curved sides...maybe curved front, see how i go.
is this a problem, should i just unwind it 3 or 4 rounds?
oh and btw i got 3 5 watt resistors, a 2.7, a 3.3 and a 4.7(should have been 3.7 but they got it wrong and i didnt check)
Okay and as for the box i will design my own, possible curved sides...maybe curved front, see how i go.
Michael, please read carefully..........it's not 2.5mH, it's 0.25mH - zero point two five.
I'll say it again - 0.25mH, note where the decimal point is. Otherwise you'll have no mids.
Take the 2.7mH back and get a 0.33mH and unwind 2 rows.
I'll say it again - 0.25mH, note where the decimal point is. Otherwise you'll have no mids.
Take the 2.7mH back and get a 0.33mH and unwind 2 rows.
ohhhhh, damn im thick, could i unwrap mine till i get 0.25?
just worked it out and that 2.7 would cross at 470Hz
maybe i should just take it back, yep ill do that, ill have the chance to drop in tomorrow after work.
whooopsie
just worked it out and that 2.7 would cross at 470Hz
maybe i should just take it back, yep ill do that, ill have the chance to drop in tomorrow after work.
whooopsie
- Status
- Not open for further replies.