All of the outputs in the 300/2 are the IRF540.
Ah ok, thanks, but don't is strange? This ampli have 4x IRF540 and 4x this unknow mos..
I don't know what the factory recommends. I've found a lot at 4mv which I believe is excessive. I prefer setting them as in the demo below:
http://www.bcae1.com/temp/ausettingbias.swf
http://www.bcae1.com/temp/ausettingbias.swf
Ah ok, thanks, but don't is strange? This ampli have 4x IRF540 and 4x this unknow mos..
I could not find that part number but it could be a fast schottky rectifier similar to this. https://static6.arrow.com/aropdfcon...21ff47d54a448a832ed42182/sdp20s30_rev.1.4.pdf
It might be sitting near / connected to the coil. Do you have a schematic?
I have changed all r-channel mosfet, but i have this situation on power supply mosfet, drain pin (see picture).
The amplifier work normally, but after 5 min. The square wave is unstable and i hear the strange sound from power supply ( i think from toroid)
The amplifier work normally, but after 5 min. The square wave is unstable and i hear the strange sound from power supply ( i think from toroid)
Attachments
What are you powering the amp with?
How high is the DC voltage feeding the amp after 5 minutes?
If you lower the 12v power supply voltage, that waveform will probably look more like you're expecting.
I powering with 40A switching power supply, 12.6V.
What is "dc voltage feeding the amp"? You mean rail voltage?
is the voltage steady at 12.6v?
Is it adjustable?
Yes, i have tryed also with 14.0V, but is the same. I have this square wave unstable also on sg3525 output..
is the voltage steady at 12.6v?
Is it adjustable?
Yes, i have tryed also with 14.0V, but is the same. I have this square wave unstable also on sg3525 output..
i have played low volume music, i must try with high volume.If you play music at a fairly high level, does the amp do this?
Does it produce music normally when the instability starts?
i don't know, let you know.
i have misured also square wave on SG3525 output, is clean, but when instability start (change frequency), also this square wave is unstable. can be sg3525 broken?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Unknow mosfet