Get a nice new aluminum chassis. Outer coating of aluminum oxide. Very hard and beautiful. Ready to do a nice single-ended tube amp.Do what is good? Please also give Ideas.
Behind posted SCH. Inside 6J1 usage correctly? There are so used 6J1 friend Please advise.
Currently existing devices as shown:
Behind posted SCH. Inside 6J1 usage correctly? There are so used 6J1 friend Please advise.
Currently existing devices as shown:
Last edited:
This is the output transformer (5/3.5K: 8). Core tongue width: 28mm. Core stack thickness: 40mm
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
I'd like to advice You SE 6S19P /+U plate about 160v/ & 6SL7. You can use OT wires for 3.5 kohm.
6s19p
Thank you! 6s19p in China's model is 6c19, We here at very cheap prices equivalent to four eggs., I did like the model.
120v power output by the voltage doubler rectifier is 280v or so, toroidal transformer power enough, so there is plenty to choose.
Attachments
Last edited:
I'd like to advice You SE 6S19P /+U plate about 160v/ & 6SL7. You can use OT wires for 3.5 kohm.
6s19p has a higher gate voltage. If you choose 6s19p, 3.5K only about 1.1W output. Feeling a little too small.
6s19p
Thank you! 6s19p in China's model is 6c19, We here at very cheap prices equivalent to four eggs., I did like the model.
120v power output by the voltage doubler rectifier is 280v or so, toroidal transformer power enough, so there is plenty to choose.
How about 6P1P? May be can get 3W... What software are you using to display the graph, it's very good looking.
The other cathod of the 6J6 (pin8)?
Common cathode 7 pin. Cathode connected internally, so there is no draw external connections.
Last edited:
6S19P has clear and neutral sounding and 3.5 kohm is very good load. I tried and I very liked it!
6C19 is indeed a very good tubes, at a voltage of 250v should have 2.5k impedance.
How about 6P1P? May be can get 3W... What software are you using to display the graph, it's very good looking.
20 years ago,I did in 1990 6p1 tube amp. Sound is not very good. Did not stay. 6p6p later changed into a tube amp. Not long ago replaced 6W6GT, finally has a good sound. So this is not going to reuse 6P1 it.
How about 6P1P? May be can get 3W... What software are you using to display the graph, it's very good looking.
Is a tube amp calculation tools.
Hey... Where did you get the cover for the power transformer?
Thanks,
~Tom
cover? Bought ah! If you prefer to send you a few. The problem is the high international postage.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Tubes / Valves
- Turing's new tube amps. Please give staff about.