We have had requests from one and maybe two individuals about an audio swap meet. No problem, however there are several stipulations:
1. You watch your own stuff, no one else is responsible for your "stuff"!
2. All unsold "stuff" goes home with the owner after the meet.
3. You provide your own table.
As a reminder, the PNWAS ("the Club"), nor "The Puget Sound! DIY Speaker Contest" is in any way connected to, or responsible for, the swap meet.
Best Regards,
TerryO
1. You watch your own stuff, no one else is responsible for your "stuff"!
2. All unsold "stuff" goes home with the owner after the meet.
3. You provide your own table.
As a reminder, the PNWAS ("the Club"), nor "The Puget Sound! DIY Speaker Contest" is in any way connected to, or responsible for, the swap meet.
Best Regards,
TerryO
Cal and I shook hands not six hours ago as the Ferry was nearing the dock and he hasn't revealed the message yet!
😕
Best Regards,
TerryO
Terry - Cal's standard boiler plate excuses would either be that "rum was involved" , or "I was just being cryptic, Terry"
CSS will be represented
Hi,
Jim Livingstone will be attending on behalf of Creative Sound Solutions and will bring our new Criton.1T kit assembled to enter into the appropriate contest.
If you need anything let us know and he may be able to bring stuff along.
Bob
Hi,
Jim Livingstone will be attending on behalf of Creative Sound Solutions and will bring our new Criton.1T kit assembled to enter into the appropriate contest.
If you need anything let us know and he may be able to bring stuff along.
Bob
Hi Bob,
We'll be looking for Jim this next weekend. I was sorry to hear that you couldn't make it to "The Mountain" this last weekend. It looked like rain with the overcast skies, but it never started. Of course as we were leaving on Sunday the Sun came out and it was wonderful!
Best Regards,
Terry
Wish you could been here as well! We had bit smaller turnout than usual, but all the entrys were quite good! Not a bad design in the whole lineup. We'll get into a bit more detail in the next couple of days and hopefully have some decent pictures as well.
😀
Best Regards,
Terry
Jim had a good time and our entry was well received.
This was for the Criton.2T in the prototype ML-TL cabinets. We will post more after we get the measurements taken.
Bob
This was for the Criton.2T in the prototype ML-TL cabinets. We will post more after we get the measurements taken.
Bob
Hi Don,
I'll try to get some posted for you and the guys in the next couple of days! I haven't forgotten!
Best Regards,
Terry
- Status
- Not open for further replies.