The Pass Pub: The High-End Off Topic Thread

Attachments

  • motel.jpg
    motel.jpg
    27.9 KB · Views: 105
And for the zumba master: Today we fixed the gas and oiltank attachments to the frame, cut the rear fender to 180 degrees and took it all apart again for a new blow job with paint, no pix

ook ..... nice to hear that there's a progress

mine Tinker Bell is progressing too

some work around camshaft finished ,
carbs split from two to one , new inlet manifold ,
new boxes for battery, electric and tool ,
new seat ready for upholstering ,
tank , front fender and new back fender with new mounting hardware are at paint shop ,
speedo case and mounting on risers ,
shock silent blocks redone from bearing plastic ,
new mufflers made of SS,
new bearings for back end

still some work to do - mainly on wiring and some mechanical

practically - barring engine case , every bolt was dismantled and inspected .... in the end it would be much different to HD wanabee as it started from factory ...... except few bearings and chain/sprocket set , everything new will be strictly DIY

will put some info and few pics in my blog , as soon I finish ..... in a month , hopefully
 

Attachments

  • Raptor-Spyder-Eos.jpg
    Raptor-Spyder-Eos.jpg
    115.8 KB · Views: 107
  • IMG_2339.jpg
    IMG_2339.jpg
    128.1 KB · Views: 96
  • IMG_2340.jpg
    IMG_2340.jpg
    122.7 KB · Views: 101
  • IMG_2341.jpg
    IMG_2341.jpg
    143 KB · Views: 98
  • Tinker_Bell.jpg
    Tinker_Bell.jpg
    89 KB · Views: 100
ook ..... nice to hear that there's a progress

mine Tinker Bell is progressing too

some work around camshaft finished ,
carbs split from two to one , new inlet manifold ,
new boxes for battery, electric and tool ,
new seat ready for upholstering ,
tank , front fender and new back fender with new mounting hardware are at paint shop ,
speedo case and mounting on risers ,
shock silent blocks redone from bearing plastic ,
new mufflers made of SS,
new bearings for back end

still some work to do - mainly on wiring and some mechanical

practically - barring engine case , every bolt was dismantled and inspected .... in the end it would be much different to HD wanabee as it started from factory ...... except few bearings and chain/sprocket set , everything new will be strictly DIY

will put some info and few pics in my blog , as soon I finish ..... in a month , hopefully
Dodo, is there 2 fullsize Samsonite and a cabin bag under the seat? Lookkking goud. Bet u will kick b4 I do. Cheers dodos.