Now the crossover itself had two non-polar caps which I replaced with film caps as I wanted the speakers to be something that 30 yeas down the road I don't have to open up and recap.
Now would there be any use to using the DATS V3 connected to the whole speaker to see what it measures like?
Now would there be any use to using the DATS V3 connected to the whole speaker to see what it measures like?
Skuttle the zobels and save about $140.00
That's a good idea, run an impedance check on both systems, all wired up and ready to play. I do it all the time before connecting it to an amp.
That's a good idea, run an impedance check on both systems, all wired up and ready to play. I do it all the time before connecting it to an amp.
It's OK, Horneydude. klipschorn is now using the default text colour which automatically fits with each theme. (This is not something we had to worry about on the old forum.)Most sites I've been to with dark mode change the text color to white for dark mode.
At some point when I have the money I need to get four cabinets built to the following internal dimensions.
I'd probably use 3/4" thick wood.
H 45"
W 11"
D 7"
Which will be 2.005 cubic feet.
I may mount the drivers on the front and use grills over each one.
I'd probably use 3/4" thick wood.
H 45"
W 11"
D 7"
Which will be 2.005 cubic feet.
I may mount the drivers on the front and use grills over each one.