Exactly how did you do that?I tied the stereo without a splitter
On the rear panel of the LAB there are 3 pushbutton switches right in the middle.
The left switch applies a 180deg phase shift to output B... make sure this is not on.
You probably do want to set it for parallel operations though, so the middle switch Link A-B should be on.
The left switch applies a 180deg phase shift to output B... make sure this is not on.
You probably do want to set it for parallel operations though, so the middle switch Link A-B should be on.
is left on normal, everything is left at 0 without low sum, everything is in phase ie tops plus subwoofers, this happens when I apply low sum , then I have to press the reverse button otherwise they are out of phase
cables XLR normal. the thing is that the ev boxes leave them fullrange and then I think that the frequencies overlap with low sum activated it s possible.
cables XLR normal. the thing is that the ev boxes leave them fullrange and then I think that the frequencies overlap with low sum activated it s possible.
Last edited:
- Home
- Loudspeakers
- Subwoofers
- Sound System