Hello
i'm sorry amc32 😱
In fact i've wait the service manual on the forum and not on my email 🙄
I've just seen the *.doc file that you sent me, thanks a lot for that 🙂
but i already have this file.
i'm sorry amc32 😱
In fact i've wait the service manual on the forum and not on my email 🙄
I've just seen the *.doc file that you sent me, thanks a lot for that 🙂
but i already have this file.
Hello
I've replaced the "1 kohms" resistors R66 and R67 and the pop noise is less audible 😕 and i just here a little click in the speaker it's not a complete repair but it is better than before.....
i wait an answer from sinuslive, i will buy the module...
I've replaced the "1 kohms" resistors R66 and R67 and the pop noise is less audible 😕 and i just here a little click in the speaker it's not a complete repair but it is better than before.....
i wait an answer from sinuslive, i will buy the module...
Hello,
Yes the amp works now, but i change it for a better amplifier.
I have bought a JBL amplifier and the sound is really good
and bass are warm and clear 🙂My sinuslive amplifier is in its box....
Hi, GROUND ZERO, i have the same with this amplifier... can you tell me if fixed the defect by replacing the module? can you inform me of the price of the module?Thanks a lot.
SinusLive sla 1500
Hi there.
Did you replace the module at the end of the repair of your amplifier?
Hello,
Yes the amp works now, but i change it for a better amplifier.
I have bought a JBL amplifier and the sound is really good
My sinuslive amplifier is in its box....
Hi there.
Did you replace the module at the end of the repair of your amplifier?
- Status
- Not open for further replies.