You are right 🙂
Anyway, if I start with only a 500 ohm trimmer can I expect to be able to get 35Vout ?
I remembered now I had a couple of 47K Z-Foil 0.1%. So I dug them up. No, they are 47K. Its the UT-61E that shows both 46.93K. The LCR meter when in range 2 & 1kHz (calibrated short and open on its Kelvin leads just before), cycles 46.99K and 47.00K every half a second. My 50000 count DMM shows 46.995K when delta zeroed. Check your R4 again too. Caps at 1kHz they must be measured, cycle ranges manually. R.C. he is gonna pull the sims out instantly, I see it coming.😀
I did check with my LCR meter and got the same values. Only cross checked with the UT-61E. May I will make a fresh calibration with my LCR and check again.
Range 2, 1kHz remember. Gave me surely smack close to 47.00K on both EQU ser par. Those resistors are laser trimmed to 0.1% 0.2ppm grade if you got them from England. They can not really be 46.93K. They can be 47K +/-47 Ohm max. Its the DMM which is 0.5% plus 10 counts at that range (only 4 digits utilized).
I am sure checked them at 1kHz. Got them from here : Vishay VAR-Series "naked" Z201 Z-FOIL RESISTOR
Still more than 1% now that I think about that.
Will check again.
Still more than 1% now that I think about that.
Will check again.
They can be produced from 1% down to 0.01%. You are intrepid fox as always. Watched all the details before ordering and bought pricier on the know.😀
Still better ±0.005%, I ordered mine to Michael Percy Audio, when received the resistors marked with TI 0,01%
TI mark best resistors as VAR not as TX2575
TI mark best resistors as VAR not as TX2575
The bug got to me and checked.
With hold2 at the LCR and got 46,98K on both of them.
Hope looks better now.
With hold2 at the LCR and got 46,98K on both of them.
Hope looks better now.
Thanks again Ricardo.
Will check actual values again, but not before Monday and correct if necessary.
Will check actual values again, but not before Monday and correct if necessary.