I've calculated the internal volume I need and also the dimensions of the port. Do I have to increase the volume of the box by the amount of space the port tube occupies (if it were imagined to be solid and not tubular)? Hope you get what I mean.
Thanks.
Thanks.
I don't believe you have to compensate for it as though it were solid, but you should take into account the length and thickness of the port.
Ok, so it's 2:1 in favour of treating the port as a sold cylinder. Any further opinions? Anybody know as a matter of fact? 🙂
Sorry, I seem to have misinterpreted your question. Yes, the port tube should be treated as a solid cylinder.
why is the port be treated as a solid cylinder when it is hollow? dont you only take into account the space occupied by the actual port tube, instead of treating it as a solid cylinder?
pk,
.... because the air inside the port acts as a "lump" of mass that is attached to the "spring" that is the net air volume in the enclosure. Together, the spring-mass system form a resonant system.
You really should buy the LDC of Vance Dickason, or at least skim through it when you happen to see one at a bookstore 🙂
Isaac
[Edited by f4ier on 11-25-2001 at 10:25 AM]
.... because the air inside the port acts as a "lump" of mass that is attached to the "spring" that is the net air volume in the enclosure. Together, the spring-mass system form a resonant system.
You really should buy the LDC of Vance Dickason, or at least skim through it when you happen to see one at a bookstore 🙂
Isaac
[Edited by f4ier on 11-25-2001 at 10:25 AM]
Pass DIY Addict
Joined 2000
Paid Member
What is critical about the port is NOT its lenght, its diameter, or its wall thickness. The importance of the port is the MASS OF AIR that it contains. This mass acts as a braking system for the driver and works to tune the box. Therefore, your calculations of enclosure size, as determined by your software, will then need to be increased by the ENTIRE VOLUME displaced by your port, by your driver, by any bracing, and by the presence of an amplifier that resides inside the enclosure.
Thus your total volume for wood cutting purposes should be: Volume calculated by software + volume of port + volume of driver + volume of bracing + volume of amp.
Thus your total volume for wood cutting purposes should be: Volume calculated by software + volume of port + volume of driver + volume of bracing + volume of amp.
- Status
- Not open for further replies.