these drivers......
... ok, I have had a look at the curves etc. and make the following comments re suitability
The TC18 has a broad rise in the 2k - 5k range, the TC26 is NICE !!
That broad rise would be accentuated with a low zeta x-o, and the sound would probably be very forward.
What I would do with this pairing is to cross higher, say 3k, use an slightly over-damped zobel on the woofer, and use a zeta of about 1.3 to counteract the rise in response of the TC18. Since you are using it with a sub, i don't imagine any bass boost needs to be added.
If you like I will put together a possible x-o diagram that should do a reasonable job, but seeing I haven't actually used either driver, would need some tweaking.
Email me if interested.
... ok, I have had a look at the curves etc. and make the following comments re suitability
The TC18 has a broad rise in the 2k - 5k range, the TC26 is NICE !!
That broad rise would be accentuated with a low zeta x-o, and the sound would probably be very forward.
What I would do with this pairing is to cross higher, say 3k, use an slightly over-damped zobel on the woofer, and use a zeta of about 1.3 to counteract the rise in response of the TC18. Since you are using it with a sub, i don't imagine any bass boost needs to be added.
If you like I will put together a possible x-o diagram that should do a reasonable job, but seeing I haven't actually used either driver, would need some tweaking.
Email me if interested.
Andy that would be great. I am new to series XO.
I prefer a laid back sound. how does one use an slightly over-damped zobel on the woofer? will a higher zeta (1.3) mean a lower slope (less than 6db/oct)?
Also at 3k the tweeter would be better protected so I woudl prefer 3k. I was just afraid ofteh rise in the woofer response and hence chose 2k.
Thanks again in advance.
regards
navin
I prefer a laid back sound. how does one use an slightly over-damped zobel on the woofer? will a higher zeta (1.3) mean a lower slope (less than 6db/oct)?
Also at 3k the tweeter would be better protected so I woudl prefer 3k. I was just afraid ofteh rise in the woofer response and hence chose 2k.
Thanks again in advance.
regards
navin
email me !!
I will need to send a diagram, so I need your email address.
If you email me I can reply with necessary info and diagram.
email address removed -- please see post below. dave (moderator hat)
I will need to send a diagram, so I need your email address.
If you email me I can reply with necessary info and diagram.
email address removed -- please see post below. dave (moderator hat)
Re: email me !!
Andy, All. We are starting to discourage the use of email addresses in the posts so as to discourage the SPAMbots that go out and find addresses to send SPAM to.
Please use the email button at the bottom of the post.
dave (moderator hat on)
Andy Graddon said:If you email me
Andy, All. We are starting to discourage the use of email addresses in the posts so as to discourage the SPAMbots that go out and find addresses to send SPAM to.
Please use the email button at the bottom of the post.
dave (moderator hat on)
- Status
- Not open for further replies.
- Home
- Loudspeakers
- Multi-Way
- Series xover design