Hello everyone!
Just found this forum and have a question.
Does anyone have experience with Seas standardline drivers?
Im useing two Seas P17RCY midbass and a Seas 27TFFC tweeter in a MMT-configuration, each chamber 18 liter tuned @ approx 40Hz
Any ideas / suggestions / tips are welcome 🙂
Take care, Martin @ Sweden.
currently useing this filter:
Just found this forum and have a question.
Does anyone have experience with Seas standardline drivers?
Im useing two Seas P17RCY midbass and a Seas 27TFFC tweeter in a MMT-configuration, each chamber 18 liter tuned @ approx 40Hz
An externally hosted image should be here but it was not working when we last tested it.
Any ideas / suggestions / tips are welcome 🙂
Take care, Martin @ Sweden.
currently useing this filter:
An externally hosted image should be here but it was not working when we last tested it.
This pairing......
This pairing should be basically PERFECT for a 1st order series x-o, probably using just 3 components (maybe an extra resistor). crossing anywhere from 2200 to 3000.
Go to my web site http://home.iprimus.com.au/gradds/ for a read about series x-o.
Up until very recently, I have not been able to easily get the Seas Drivers over here (Australia) so I haven't actually used this pairing, but it is one that is on my list for the near future when funding becomes available.
Email me if you want to try a series x-o and need help.
Good Luck !!
This pairing should be basically PERFECT for a 1st order series x-o, probably using just 3 components (maybe an extra resistor). crossing anywhere from 2200 to 3000.
Go to my web site http://home.iprimus.com.au/gradds/ for a read about series x-o.
Up until very recently, I have not been able to easily get the Seas Drivers over here (Australia) so I haven't actually used this pairing, but it is one that is on my list for the near future when funding becomes available.
Email me if you want to try a series x-o and need help.
Good Luck !!
- Status
- Not open for further replies.