Hi there, I am currentlly ripping apart a Rogers A100 class B 55 watt per channel amplifier to use it's power amp sections as monoblocks. I will be using a seperate power supply for each that should help boost the wattage and it's ability. It uses some form of current dumping so runs nice and cool when quiet.
I was wondering if anyone had any information on the Rogers A100, about it's designs etc.
I was wondering if anyone had any information on the Rogers A100, about it's designs etc.
Last edited:
Hi,
Is it ClassAB?
Do you have a circuit/schematic?
Do you intend fitting bigger heatsinks?
does not equate.ClassA .... &.... runs nice and cool
Is it ClassAB?
Do you have a circuit/schematic?
Do you intend fitting bigger heatsinks?
Just about the only integrated i'm aware of that uses the amp's back panel as a heatsink.
2 Motorola TO3 output devices per channel, about 5 watts in Class A would be more truthfull.
The heatsync is the two black bits in middle and they have vents below and above them
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Solid State
- Rogers A100