Post a photo of the signal on pin 7.
The amp does not draw excess current, and it out of protect, plays good sound from what I can tell. Sometimes its hard to hear distortion at 50Hz.
Although there is a slight and faint whine inside sometimes.
Photo 1 is of pin 7 U11
Photo 2 is of pin 1 U11
Attachments
Adjust the trigger level. It appears that it's not locking on the signal.
Thats what I thought but when I was moving the trigger it was moving the whole display up and down like you were adjusting the display position knob. Any thoughts???
Does the switch for DC coupling make a difference?
Is the 'source' switch next to the coupling switch set to norm or to ch2 (assuming that you're still using ch2)?
I have not tried it on normal its still set on channel 2 should I try it on normal?
Are you seeing precisely what it looks like in the photos?
Is the waveform moving left to right?
Yes I am still seeing what I posted in the pics, but the signal is ever so slightly bouncing up and down not moving horizontally. The amp is working so should I not worry about it or ?? Any thoughts ??
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Rockford Fosgate BD15001 stuck in protect