Perry to have anything on the gate pads I have to set my scope to 50v 4.00ms and probe set to x1
Having it set to the same as when you were looking at the square wave on pin 7, you don't see a signal?
Do you now have the 50Hz signal?
The low-side will be on the negative rail. The high-side will be at ground level.
Do you now have the 50Hz signal?
The low-side will be on the negative rail. The high-side will be at ground level.
Sorry the wife said I had to eat.
I do have signals on the pads probe x10 10v 4.00ms
Sound comes on when I get the sq waves.
I do have signals on the pads probe x10 10v 4.00ms
Sound comes on when I get the sq waves.