Hello!
Me and friends are considering to build an Aikido 6SN7 linestage with tube regulated power supply and tube rectification as well.
2 x 5R4 -> LC choke -> electronic choke (330mf cap onboard right at the input) -> Janus -> Series tube regulator (6080, 6SL7 and OB2).
1) If the Tentlabs e-choke is using, is Janus being necessary?
2) What tube will you suggest for Janus if you agree the diagram of above?
thx!
Me and friends are considering to build an Aikido 6SN7 linestage with tube regulated power supply and tube rectification as well.
2 x 5R4 -> LC choke -> electronic choke (330mf cap onboard right at the input) -> Janus -> Series tube regulator (6080, 6SL7 and OB2).
1) If the Tentlabs e-choke is using, is Janus being necessary?
2) What tube will you suggest for Janus if you agree the diagram of above?
thx!
I remember using this type of neon valve to stablise a 105Volt supply. Heat ... didn't need any heating on in the room!!
Hopefully you will set it up as if it were a Zener Diode and split the strike voltage to get the required result and not just shunt the HT.
330uF is too high for a valve rectifier, you will strip the cathodes.
Hopefully you will set it up as if it were a Zener Diode and split the strike voltage to get the required result and not just shunt the HT.
330uF is too high for a valve rectifier, you will strip the cathodes.
Well, the Tentlabs module include 330mf for C in and require another 330mf after that:
Electronic Choke
Electronic Choke
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.