Quasimodo results (ONLY)

[Mark Johnson]

Talema 70065K // blue encapsulated PC mount transformer // 25VA // dual primary // dual secondary: 2 x 22VAC

Cx = 10 nF
Cs = 1000 nF (== 1.0 microfarad)
Rs = 44 ohms

 

[Mark Johnson]

Amgis L01-6365 // blue encapsulated PC mount transformer // 25VA // dual primary // dual secondary: 2 x 22VAC

Cx = 10 nF
Cs = 1000 nF (== 1.0 microfarad)
Rs = 63 ohms

Remember, this thread is Quasimodo results ONLY

 

[deerhunt]

Toroid Int AB
1500VA 230VAC, unwinded some turns for lowering sec voltage to 2*50VAC.

Cx=10nF
Cs=100nF
Rs =22ohm

Picture shows undamped also.

 

[ranshdow]

Talema 62065-P2502
25VA, 2 x 22VAC

Cs = 1uF
Cx = 10nF
Rs = 33R

Note these Cx, Cs values are different from the default Quasimodo values, These values are the ones used in the onboard snubbers of the UDP3.

 

[Plott]

Hi,
just a short question: has anyone measured the audio grade Toroidy TS400VA with 2x28vac?
Many thanks in advance.

 

[Wellerman]

Amplimo 18013
30VA, 230V / 2x15VAC
Cs = 150nF
Cx = 10nF
Rs = 33R (average, found 36R for 1 secondary, 31R for the other)

 

[dantwomey]

Plitron #201020 300VA 18VAC Sec


C2 = 10nF,
C3 = 150nF
Rs = 10R

 

[druidaudio]

Vigortronix VTX-146-100-209
100VA Primaries in series (230v), separate secondaries (2 x 9v)
Cs = 150nF
Cx = 10nF
Rs = 11R

 

[6L6]

Talema 70053K secondaries individual.

C2 = 10nF,
C3 = 150nF
Rs = 68R





(Pokémon optional…)

 

[Mark Johnson]

Amgis L01-6345 // blue encapsulated PC mount transformer // 10VA // dual primary // dual secondary: 2 x 22VAC

Cx = 10 nF
Cs = 1000 nF (== 1.0 microfarad)
Rs = 98 ohms

Remember, this thread is Quasimodo results ONLY

 

[Mark Johnson]

Talema 70055K // blue encapsulated PC mount transformer // 15VA // dual primary // dual secondary: 2 x 22VAC

Cx = 10 nF
Cs = 1000 nF (== 1.0 microfarad)
Rs = 60 ohms

Remember, this thread is Quasimodo results ONLY

 

[cpseymour]

Amgis L01-6353
2X15VAC 15VA Blue Encapsulated
Cx = .01uF
Cs = .15uF
Rs = 88.6Ω

 

[Gricko]

Does anyone have the values for Triad FS48-750-C2 with independent Secondaries ? Thank you !

 

[paulebappie]

Hammond 185F230 Input 230V Output 230V
Cx=10nF
Cs=150nF
Rs=950 Ohm

 

[johan]

YHDC Electronic Co, PTC25 25VA 15Vx2, input 230 V (series), output 15 V (parallel)
Cx = 10 nF
Xs = 150 nF
Rs = 77 ohm

 

[floyd89gr]

Breve Tufvassons TEZ16 16VA , 230V in 7.5V out
Cx = 10nF
Xs = 150nF
Rs = 220 - 270 Ohm

Myrra 45031 10VA , 230V in 2x6V out
Cx = 10nF
Xs = 150nF
Rs = 270 Ohm

Hahn BVUI3040173 10VA , 230V in 2x21V out
Cx = 10nF
Xs = 150nF
Rs = 1KOhm

Talema 70064k 25VA , 230V in 2x18V out
Cx = 10nF
Xs = 150nF
Rs = 27 Ohm

Talema 70065k 25VA , 230V in 2x22V out
Cx = 10nF
Xs = 150nF
Rs = 27 Ohm

Talema 70060K 25VA , 230v in 2X7V out
Cx = 10nF
Xs = 150nF
RS = 12-15 Ohm

Talema 70063K 25VA , 230V in 2x15V out
Cx = 10nF
Xs = 150nF
Rs = 27 Ohm

Talema 70053K 15VA , 230V in 2x15V out
Cx = 10nF
Xs = 150nF
Rs = 68 Ohm

 

[Mark Johnson]

Talema 70053K 15VA , 230V in 2x15V out
Cx = 10nF
Xs = 150nF
Rs = 68 Ohm

Compare against post #149 of this thread. 3 & 1/2 months ago

 

[Halauhula]

@Mark Johnson: Do you think the two results shows very good quality control by Talema?

 

[myleftear]

toroidy audio-grade TS50VA 2x15V :
(Configured as center-tap)
Cx = 10nF
Xs = 150nF
Rs = 198R

 

[tgrier]

Anyone have data for the Antek AS-4220 was thing of using that one for my Aleph Jzm build. Thanks, Tony