when i measure the DC voltage on the 1st pin of the driver board om only reading 9.5mv instead of 4.3. what could be causing that?
Pin 1 of the driver board can't have signal if you don't have 12v above the negative rail.
Is there a D22 and D23 that feed that regulator?
Is there a D22 and D23 that feed that regulator?
mnhiphop101 hi I have this same amp i bought to repair but it's missing the regulators by the driver board and the small caps connected to the regulators and was wondering if it's not to much trouble if you could email or post on here some pics of the board in that area please. It would be much appreciated thank you
Please don't post in a repair thread that was started by someone else unless you are trying to help them.
Start a new thread if you need help with a repair of your own.
Start a new thread if you need help with a repair of your own.
Ok sorry Perry I was reading the thread and seen it was the same amp I have here and needed some pics but I'll make new thread.