They generally short where the terminal winding closest to the outputs comes up over the top and goes back down into the core.
When you get the outputs replaced again, clamp them tightly to the sink and use a current limiter. If there is excessive current draw, twist the inductors to see if twisting them causes a change in the current draw.
When you get the outputs replaced again, clamp them tightly to the sink and use a current limiter. If there is excessive current draw, twist the inductors to see if twisting them causes a change in the current draw.
Attachments
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.