Hey All,
I trying to design a ported encloser for my audiobahn 1006t sub the specs recommend are as follow:
Air Space (cu/ft) = 1.4
Port size = 3" x 6.75
Port Vel: = 24.19
-3db Hz = 30
Tune Freq. (Hz) = 39
Sub (Disp cu/ft) = 0.21
Port (Disp cu/ft) = 0.024
Total Volume (cu/ft) = 1.5
Now, this is the deminsion of my box design: using 3/4 MDF
Height = 20"
Width = 19"
Depth 1 = 8.5"
Depth 2 = 12"
Total = 1.639 cu/ft
I used http://www.bcae1.com/spboxnew2.htm to input all the values...but Im still confused as to where the port goes, does it has to be a 3" hole ...6.75 deep? and where? ...after putting all the values in it came back with a net volume of 1.4(cu/ft) just what the manual recommends for the sub.
Can someone pls help me out?.....Thanks to all
I trying to design a ported encloser for my audiobahn 1006t sub the specs recommend are as follow:
Air Space (cu/ft) = 1.4
Port size = 3" x 6.75
Port Vel: = 24.19
-3db Hz = 30
Tune Freq. (Hz) = 39
Sub (Disp cu/ft) = 0.21
Port (Disp cu/ft) = 0.024
Total Volume (cu/ft) = 1.5
Now, this is the deminsion of my box design: using 3/4 MDF
Height = 20"
Width = 19"
Depth 1 = 8.5"
Depth 2 = 12"
Total = 1.639 cu/ft
I used http://www.bcae1.com/spboxnew2.htm to input all the values...but Im still confused as to where the port goes, does it has to be a 3" hole ...6.75 deep? and where? ...after putting all the values in it came back with a net volume of 1.4(cu/ft) just what the manual recommends for the sub.
Can someone pls help me out?.....Thanks to all
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.