Plinth for Thorens 150 & 160

[kogj83]

Hello. Im planning on building a plinth for Thorens 150 and 160. Does anybody have the inside dimensions for them both or a plinth drawing. All help will be highly appreciated. 🙂

Thanks

 

[lexx21]

I am very interested in this as well.

 

[titus2002]

You are welcome. A lot of information on restorations, tuning and construction of plinths on Analog Dept

 

[planet10]

I tidied that photo into a drawing, someone else will need to translate the relavent German notes.

dave

 

[PRR]

...someone else will need to translate the relavent German notes....

It is a Rosetta Stone. Same words in different languages. Here's the English for your copy/paste. (Of course if you can bind titus2002's image into your PDF, French and Germans can squint their words.)

WARNING
This template may shrink in storage or if glued onto a wooden board. It is therefore advisable to check the dimensions before cutting out and to make corrections if necessary.

THORENS
TD150/II
Mounting template

The exact position of the 5 holes shall be taken from the chassis

The 3 seatings may be milled off 7/64" (2,8mm) or replaced by battens if required.

(sideways)

Seatings milled off.

Mounting with battens.

 

[planet10]

Oops… blindness caused by looking only at the 1st line. Thanx.

dave

 

[planet10]

I’ve updated the post above.

dave

 

[kogj83]

Awesome @planet10. Thanks a million.