Does anyone have a pic of this board assembled that they could post? I can't seem to find one of the V2.0, only V1.0. I want to make sure I have everything in the right place and with q5 and q6 in the right orientation.
you need to check the datasheets for the parts in question . they will make everything very clear .
look up your part # on digikey or mouser and then click on the link for the datasheet .
cheers Woody
look up your part # on digikey or mouser and then click on the link for the datasheet .
cheers Woody
I checked the data sheet but this is my first amp an want to be sure I did it right. If I can post a pic could someone make sure I assembled it correctly?
Dj, sorry about that, I didn't read your post correctly.
Post pics and which parts you are using(ZTX, etc)
jim
Post pics and which parts you are using(ZTX, etc)
jim
dj , in that case 😉 i don't have a set populated to photo , but i've a empty set i'm looking at .
holding them so the printing is right side up Q6 is on the left and assuming you're using the ZTX450 , the "flat side " should be facing you . Q5 is on the right and assuming ZTX550 the "curved side" should be facing you .
hth
cheers Woody
holding them so the printing is right side up Q6 is on the left and assuming you're using the ZTX450 , the "flat side " should be facing you . Q5 is on the right and assuming ZTX550 the "curved side" should be facing you .
hth
cheers Woody
Woody that was exactly what I needed to know. Just to be sure Q2 and Q1 should have their flat sides facing each other.
I had this same issue a while back but never saw a photo either.
This PDF does have some info you might find handy if you haven't already seen it.
I also found this photo of some use.
Best of luck
Dean
This PDF does have some info you might find handy if you haven't already seen it.
I also found this photo of some use.
Best of luck
Dean
Attachments
Last edited:
- Status
- Not open for further replies.