Hi,
Quick question: With no power switched on. When checking for continuity between the amp output and the heatsink is the PSU connected to the amp module in any way, including the ground wire for the heatsink ?
Thanks,
MM
Quick question: With no power switched on. When checking for continuity between the amp output and the heatsink is the PSU connected to the amp module in any way, including the ground wire for the heatsink ?
Thanks,
MM
The reason for the question in post#1823 is that with just the amp board mounted on the heatsink (no connection to the psu) and the DMM with COM the black probe attached to heatsink fin and red probe on the amp output. With the DMM in continuity mode I read an OL on the DMM. All the legs on the Mfets are reading OL also.
Earlier comments from shaan indicate that this is correct and one can proceed with further testing. Is this correct?
If I connect the psu to the amp board, heatsink to psu gnd, sgnd and pgnd to psu gnd, with no power applied, then the DMM reads resistance from the output and from the Mfets legs. Is this normal operation also ?
Thanks for the help,
MM
Earlier comments from shaan indicate that this is correct and one can proceed with further testing. Is this correct?
If I connect the psu to the amp board, heatsink to psu gnd, sgnd and pgnd to psu gnd, with no power applied, then the DMM reads resistance from the output and from the Mfets legs. Is this normal operation also ?
Thanks for the help,
MM