• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Parts needed for 3A amp. project

Status
Not open for further replies.
Jump to Latest
N

NerdMike

Member
Joined 2002
I'm building an ESP 3A amp. and I could use a couple items to upgrade and i would rather not place a forth minimum order. I need 4 -100 pf. polystyrene caps, 0.5 ohm non inductive 5 watt resistors ( ideally 1 percent), a killer pair of input caps (2-5 uf).
I will buy or trade for your needs. I do have some Dale RS-5 watt one ohm, 0.1 percent factory resistors. Good for calibration, etc. I also have a Belles model two amp. chassis. It has heat sinks on both sides for a total of eight T-03 output devices. Complete with RCA's and binding post, electrolytic caps.
Thank you,
Mike
 
Status
Not open for further replies.
Top Bottom