Do you mean like these
CBSB-8-01A2-RT - RICHCO - PCB SUPPORT TAPED BASE 12.7MM | Farnell United Kingdom
CBSB-8-01A2-RT - RICHCO - PCB SUPPORT TAPED BASE 12.7MM | Farnell United Kingdom
How much is noise RMS at 500uV sens for full out bandwidth and 20MHz limit with the crock clip shorting the probe's tip?
Here the pictures, Ch1 shorted, Ch2 open, Ch1 20Mhz, Ch2 100Mhz
Attachments
Danke an Alfred
und an alle die daran mitgearbeitet und viel Zeit
geopfert haben. Nun kann es losgehen, ich freue mich schon.
Liebe Grüße
Stephan
------------------------------------------------------------------------
Thanks to Alfred
and to all who worked on it and a lot of time
have sacrificed. Now the fun begins, I can not wait.
Greetings
Stephan
Here the pictures, Ch1 shorted, Ch2 open, Ch1 20Mhz, Ch2 100Mhz
Thanks. Looks like it has a good front end as DSO's go for noise.
It´s like this.
One possibility that can be transported. The pads can be cut and made smaller or used at the edges.
I use a single, little off centre, screw to tension the PCB safer on the pads when choosing some give in mounting. SYLOMER supporting blocks under green boards in this example.
Attachments
- Home
- Group Buys
- Paradise phono stage