Trying to put 2 Dayton PA460-8's into this cabinet.
Internal measurements are 34.5"x34.5"x16.5" which makes about 11.2 cubic feet.
I have a couple of questions....
Would the VBSS ports work in this cab? (4 in total)
Do I need to separate the drivers? (divider across the middle)
Any suggestions?
Thanks,
Todd
p.s. took me all after noon to mock up this cab. in sketchup - got a headache.
Depending on how high you plan to run the cabinet, it might be a good idea to do a push-pull arrangement with the drivers.
I was just going to run a 15"+1" on top of each cabinet - so 120hz - a little more or less. I going to use an INuke3000dsp. Was planning to use the VBSS "script" of eq's to run these too.
Add some bracing, at least as much as the V.B.S.S. Also personally I would use at least 3 x 4" diameter ports for 18" PA-cabinets (or 2 x 5").
- Status
- Not open for further replies.