Thank you, dBel84. Would you happen to know offhand what the bias setting is supposed to be for the BH EL84 version?
I have a note that says 26mA for the EL84. I happen to be listening to mine so it is all warmed up and the voltage is 0.3V
yes - this would imply that I have mine set to 30mA - 300mV across a 10ohm resistor , so if you follow the letter of the law , it should be 0.26V
I set mine up with switches and little built in V meters - it was more important for me to have all the tubes set the same and having an easy way to set them. - and now they are reading .29V 🙂
I set mine up with switches and little built in V meters - it was more important for me to have all the tubes set the same and having an easy way to set them. - and now they are reading .29V 🙂
Attachments
Last edited:
