HI!
I'm beggining my first speaker project and i need some advice on crossover.
Drivers:
http://www.d-s-t.com/vifa/data/d27tg-05-06a.htm
http://www.d-s-t.com/vifa/data/m18wo-09-08a.htm
Box: 22L, ported
I was thinking of going with 2nd order Linkwitz-Riley, crossed at 2kHz , with impedance rise compensation circuit on both bass and tweeter and L-pad attenuator (-?dB)
Whats your opinion?
I'm beggining my first speaker project and i need some advice on crossover.
Drivers:
http://www.d-s-t.com/vifa/data/d27tg-05-06a.htm
http://www.d-s-t.com/vifa/data/m18wo-09-08a.htm
Box: 22L, ported
I was thinking of going with 2nd order Linkwitz-Riley, crossed at 2kHz , with impedance rise compensation circuit on both bass and tweeter and L-pad attenuator (-?dB)
Whats your opinion?
I recommend minimum 2.5Khz and 2.5dB of attenuation for the tweeter. Usually you take a variable L-Pad, adjust to taste and use fixed resistor value to build the final L-Pad. Drivers are very similar to the one that I use in my Arro Clone.
- Status
- Not open for further replies.