Completely agree, I'm in the UK, I'm not particularly wealthy, but $10 is what an hour labour for someone hypothetically on minimum wage, I think moode is worth 1 hour of someone's labour in worth, but nobody is forced into buying it.
Why shouldn't Tims hundreds if not thousands of man hours of effort be rewarded?
LTF
Why shouldn't Tims hundreds if not thousands of man hours of effort be rewarded?
LTF
pi@moode:~ $ sudo sqlite3 /var/local/www/db/moode-sqlite3.db "update cfg_audiodev set kernel='' where id='1’"
Error: unrecognized token: "'1’"
I copy pasted the command from the previous post. It throws an error. Waiting for guidance.
ssh fails, hence verdict is DOA.
On my other system, with RPi2 and Piano DAC (not the 2.1) the RT installed with no problem.
Thanks for your reply.
John
Last edited:
1.
Link destination is PI3B Built-in WIFI does not work. The problem is different, I think.
2. and 3.
It was found that the same trouble occurs even with only PI 3B board.
(I don't use WIFI dongle, of course)
<Advanced-RT kernel without DACCARD(PI3B borad only with wired lan connection)>
System information
WIFI/BT = Off
pi@moode2:~ $ uname -r
4.4.39-rt59-moode2+
pi@moode2:~ $ cat /boot/config.txt
disable_splash=1
hdmi_drive=2
dtparam=i2c_arm=on
dtparam=i2s=on
dtparam=audio=on
dtoverlay=pi3-disable-bt
dtoverlay=pi3-disable-wifi
pi@moode2:~ $ ifconfig
eth0 Link encap:Ethernet HWaddr b8:27:eb:87:d0:32
inet addr:192.168.1.88 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::1a6:47:7205:2d36/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:419 errors:0 dropped:0 overruns:0 frame:0
TX packets:342 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:36526 (35.6 KiB) TX bytes:70030 (68.3 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:111 errors:0 dropped:0 overruns:0 frame:0
TX packets:111 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1
RX bytes:11051 (10.7 KiB) TX bytes:11051 (10.7 KiB)
wlan0 Link encap:Ethernet HWaddr b8:27:eb:d2:85:67
inet addr:172.24.1.1 Bcast:172.24.1.255 Mask:255.255.255.0
inet6 addr: fe80::445f:4fb6:4387:d361/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:287 errors:0 dropped:3 overruns:0 frame:0
TX packets:49 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:66662 (65.0 KiB) TX bytes:9333 (9.1 KiB)
My posts are getting moderated (and hence I am unable to edit earlier post).
I managed to fix the command
sudo sqlite3 /var/local/www/db/moode-sqlite3.db "update cfg_audiodev set kernel='' where id='1’"
The apostrophe before the number 1 was replaced with the single quote and it worked.
Next, I moved on to the audio configuration, after a reboot.
I could see the Allo BOSS DAC right on the top - so I selected it and tried to do all the configuration indicated in the 'readme.txt'.
I had a little trouble with mounting my NAS drive share, but in the end I managed to do that. After a few minutes, I could see the albums getting loaded up in MoOde. I got pretty excited and tried to play a track. There was no sound.
I noticed that the Volume level was 0 - so I changed that to 20 - still no sound.
Then I tried to increase it further and I got a warning that the limit is 25 - so I changed the limit to 30 and increased the volume to 28. Still no sound.
Something is wrong, but I am not sure what.
I managed to fix the command
sudo sqlite3 /var/local/www/db/moode-sqlite3.db "update cfg_audiodev set kernel='' where id='1’"
The apostrophe before the number 1 was replaced with the single quote and it worked.
Next, I moved on to the audio configuration, after a reboot.
I could see the Allo BOSS DAC right on the top - so I selected it and tried to do all the configuration indicated in the 'readme.txt'.
I had a little trouble with mounting my NAS drive share, but in the end I managed to do that. After a few minutes, I could see the albums getting loaded up in MoOde. I got pretty excited and tried to play a track. There was no sound.
I noticed that the Volume level was 0 - so I changed that to 20 - still no sound.
Then I tried to increase it further and I got a warning that the limit is 25 - so I changed the limit to 30 and increased the volume to 28. Still no sound.
Something is wrong, but I am not sure what.
Hi John,
Prolly a hardware compatibility issue with pi3+reclocker+audioboard and the experimental adv kernels.
-Tim
Thanks for clarifying.
Which of the two Advanced Kernels should I be using? LL or RT?
Hi,
I'm able to report this.
There is an alternate method for disabling Wifi/BT which was used in Moode 3.1. I'll run some tests later today with this method and get back to you.
-Tim
Just installed 3.5; a lot more polished interface compared to the 2. whatever version I was running.
Minimserver -> Moode 3.5 upnp or usb attached: both sound the same on my PI zero PHAT Dac Bravo headphone setup. Using BubbleUp control point.
What a great product. Way to go Tim!
Minimserver -> Moode 3.5 upnp or usb attached: both sound the same on my PI zero PHAT Dac Bravo headphone setup. Using BubbleUp control point.
What a great product. Way to go Tim!
Indeed. Replacing the Pi3 with a Pi2 enabled me to load the RT Kernel with no trouble. Sounds great. 🙂
I was interested to discover that the Piano 2.1 DAC will now output full spectrum audio through both MAIN and SUB outputs when playing 24 bit files (or with upsampling to 24 bit selected).
John
Last edited:
Installed the RT kernel. Now BOSS DAC is working.
Sounds as good as Volumio if not better.
Are there any other settings that I need to do to further enhance the audio?
I do not know anything about your friends, but my friends neither write bills nor ask me for money.
Come on, calm down, nobody forces you to buy this... Nobody got harmed in Tims decision to make some money...
If a friend does something for me that takes up their time, I buy them a bottle of wine / few beers etc
LTF
LTF
MoOde 3.5
Hi Tim!
Congrats to your fantastic work!
Only one thing:
Saving playlists doesn't work.
Greetingz, Robert
Hi Tim!
Congrats to your fantastic work!
Only one thing:
Saving playlists doesn't work.
Greetingz, Robert
...and that is some kind of what I liked in the donation system. Gentlemen know when it is time for a consideration.
Hi,
I'm able to repro the issue where AIFF tags are not being picked up by MPD update. The result suggests a possible bug in 0.20.6 MPD based on log file output below.
Added to TODO list for fixes
-Tim
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/02 Work From Smoke.aiff
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/03 Parenthetically.aiff
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/04 Every Five Miles.aiff
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/05 Thos. Dudley Ah! Old Must Dye.aiff
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/06 Is That A Rifle When It Rains_.aiff
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/07 The C In Cake.aiff
Apr 16 13:06 : audiofile: unrecognized audio file format
Apr 16 13:06 : update: added USB/VFAT-8GB2/Test_mixed/AIFF/Crookt, Crackt, Or Fly/08 The Wrong Soundings.aiff