Barry furthest hole away from the mech , just popped in 2 regs on the servo wow big improvement bass ,vocals loads better.
alan
😉
I had no probs barry worked firsttime been luck so far phew? wire length shouldnt matter mine are longer than 6 ins maybe your clock is suspect good luck .
alan
alan
Hi Alan
If you buy it off the web site paypal is one of the options ;-)
Fidelity Audio : SPower low noise voltage regulators
Brent
Thanks brent 😀 26 spowers aint goin that far 😱 like the carlsberg logo lol sorry for my poke or fun should i say last nite pink or brown lol.
alan 😉
@Barry again: Did i get that right, you're using a Tentlabs Clock? If so, the XO will probably be sitting on a socket and it COULD be that one of its pins doesen't have proper contact.
You could try and remove the XO and put it back, maybe a slight bending of the 4 legs can tighten its fit. But careful, the XO is also ESD sensitive and can (already has?) easily be damaged.....
Just a thought.
Mickie
You could try and remove the XO and put it back, maybe a slight bending of the 4 legs can tighten its fit. But careful, the XO is also ESD sensitive and can (already has?) easily be damaged.....
Just a thought.
Mickie
Should have a 63 convention love to hear your player loads of beer fall down as ya do few on here be up for that ,
alan {ps ken isi who ]
alan
alan {ps ken isi who ]
alan
Im having fun learning from u guys enjoyin every minute might have a joke lighten things p but hey that s me😀
alan
Big thanks to ian , brent ,simon, for your help and patience.
big help thank you.
alan (got a player that sounds good now)
alan
big help thank you.
alan (got a player that sounds good now)
alan
VAM12 out, too much picky with older CDRs. May find a cheap CDP to save a CDM12, some already stock them I guess =)
Last night I spent an hour or so building my output stage psu + connector cable.
Will post my impressions when I get it hooked up and tested, although I expect you know what to expect, lol.
Lee.
An externally hosted image should be here but it was not working when we last tested it.
Will post my impressions when I get it hooked up and tested, although I expect you know what to expect, lol.
Lee.
Hehe Mega!
What caps are those?
Is all that for output stage or is 1/2 for the servo too?
Brent
What caps are those?
Is all that for output stage or is 1/2 for the servo too?
Brent
Two psu's in there, one for servo and one for output.
The caps are Nichicon Low-ESR (I forget the type), which are not the best tbh. I will try upgrading the output stage ones at some point.
Lee.
The caps are Nichicon Low-ESR (I forget the type), which are not the best tbh. I will try upgrading the output stage ones at some point.
Lee.