Pcb's with plated through holes are also sensitive agaist repeated soldering.....li_gangyi said:
hello!
Jan!
How are you man? I am so excited about li-gangyi's LYNX! 😀
Can't wait for him to finish it and post pics! 😀
I still have a lot of work in my hands and that is why I can't start building the LYNX again. 🙁
Best regards,
JojoD
Jan!
How are you man? I am so excited about li-gangyi's LYNX! 😀
Can't wait for him to finish it and post pics! 😀
I still have a lot of work in my hands and that is why I can't start building the LYNX again. 🙁
Best regards,
JojoD
Re: Peranders
Aha, I got fooled by the silk print. Have you pads in "paint" on the component side?ACD said:
You mean "have your pads been painted on the component side"?? Or the solder side??? The whole PCB looks really pro...
At first the pcb looked like it had plated through holes but traces only on solder side (not the case though).
Peranders
For most diyers it's best to use single sided PCB's, as replacement of components on double sided PCB's is a bit more tricky.....😉 and on 4/6/8 layers almost impossible 😀
For most diyers it's best to use single sided PCB's, as replacement of components on double sided PCB's is a bit more tricky.....😉 and on 4/6/8 layers almost impossible 😀
Wow!
I haven't started building my amp and you are moving to new horizons... I hope I can catch up. 😀 Best regards,
JojoD
Li
I have made one in app. half size, but tracks are getting to small for a real a High Current Power Amp 😉
I have made one in app. half size, but tracks are getting to small for a real a High Current Power Amp 😉
Peranders
No problem, if I can get prepaid orders on min. 5 sets in advance.
Remember this is for fun - not business 😉
No problem, if I can get prepaid orders on min. 5 sets in advance.
Remember this is for fun - not business 😉
- Status
- Not open for further replies.