The distortion of 0.05% to 1 KHz is in maximum power?
You can use the input differential pair that should reduce the distortion.
look :
http://users.ece.gatech.edu/~mleach/papers/tcir/tcir.pdf
I did not like the output with electrolytic, very ESR in 20KHz
simulation will not show it .
You can use the input differential pair that should reduce the distortion.
look :
http://users.ece.gatech.edu/~mleach/papers/tcir/tcir.pdf
I did not like the output with electrolytic, very ESR in 20KHz
simulation will not show it .MJL21193 said:Well, you know what he looks like, right? 😀
Alrighty then, I did it. A little rough but it will do for the first complete prototype:
Silkscreen is printed on the other side. I'm taking tomorrow off so I may do a bit more with it - drill holes, add parts, etc.
Good work, I also use the contour GND...
- Status
- Not open for further replies.